Photosensitive organic-inorganic hybrid structures based on porous silicon

Abstract

In this study, the photovoltaic organic-inorganic structures were created by deposition of poly(3,4-ethylenedioxythiophene) film doped by poly(styrenesulfonate) and reduced graphene oxide on the porous silicon/silicon substrate. Formation of the hybrid structure was confirmed by means of atomic-force microscopy and Fourier transform infrared spectroscopy. The current-voltage characteristics of the obtained structures were studied. It was found the increase of electrical conductivity and photo-induced signal in organic-inorganic structures. Temporal parameters and spectral characteristics of photoresponse in the 400–1100?nm wavelength range were investigated. The widening of spectral photosensitivity in a short-wavelength range due to light absorption in various layers of the multijunction structure in comparison with single crystal silicon was revealed.     

单晶硅晶格间距的测量技术进展及应用

单晶硅晶格间距是许多重要物理常数测量的基础。本文介绍了硅晶格间距测量技术的发展历程,包括X射线干涉仪直接测量和晶格比较仪间接测量两种方法,以及影响测量结果不确定度的关键因素。得益于晶格间距测量的进展,在纳米尺度,硅晶格间距被国际计量局(BIPM)批准成为新的米定义复现形式。最后介绍了硅晶格在计量学中的应用,以及基于硅晶格实现纳米几何量测量的溯源体系的研究趋势。     

改进型单晶炉提拉系统偏心平衡研究

随着光伏行业的快速发展, 对硅单晶的品质和长晶装备的稳定性的要求也不断提高。直拉法是生产硅单晶的主要方法,通过提高单晶炉副室的高度以扩大单晶硅的生产规模。由于副室高度的大幅增加,且单晶炉提拉头质心相对于旋转轴心有一定距离,对单晶炉整体稳定性有较大影响,从而降低了单晶硅的生产质量。针对此问题,对单晶炉建立可靠的力学分析模型,采用数值仿真方法,对单晶炉整体进行动力学响应分析,计算得到副室高度增加后的单晶炉工作时中钨丝绳下端晶棒的运动规律以及最大摆动幅度,为改进设计提供依据。数值仿真分析表明提高单晶炉副室高度后,提拉头较大的质心偏心是单晶炉提拉系统发生摆动的主要原因。在此基础上提出在提拉头上添加质心调节装置,通过控制系统调节可保证提拉头质心位置在旋转轴线上以降低提拉系统的摆动。     

甲烷浓度对碳化硅基底金刚石薄膜摩擦性能影响

利用热丝化学气相沉积法(HFCVD)在碳化硅基底上制备金刚石薄膜,采用场发射扫描电子显微镜、拉曼光谱仪、原子力显微镜研究了在不同甲烷浓度条件下制备的金刚石薄膜表面形貌及物相组成,在干摩擦条件下通过往复式摩擦磨损实验测试并计算了已制备金刚石薄膜的摩擦系数和磨损率,结合物相分析及摩擦磨损实验结果分析了甲烷浓度的改变对金刚石薄膜摩擦磨损性能的影响。结果表明,由于甲烷气体含量的升高,金刚石薄膜结晶质量下降,薄膜由微米晶向纳米晶转变。摩擦磨损实验结果显示:3%甲烷浓度条件下制备的金刚石薄膜耐磨性较好,磨损率为2.2×10^-7 mm³/mN;5%甲烷浓度条件下制备的金刚石薄膜摩擦系数最低(0.032),磨损率为5.7×10^-7 mm³/mN,制备的金刚石薄膜的耐磨损性能相比于碳化硅基底(磨损率为9.89×10^-5 mm³/mN)提升了两个数量级,显著提高了碳化硅基底的耐磨性。     

Surface passivation in n-type silicon and its application in silicon drift detector

Based on the surface passivation of n-type silicon in a silicon drift detector(SDD), we propose a new passivation structure of SiO2/Al2O3/SiO2 passivation stacks. Since the SiO2 formed by the nitric-acid-oxidation-of-silicon(NAOS)method has good compactness and simple process, the first layer film is formed by the NAOS method. The Al2O3 film is also introduced into the passivation stacks owing to exceptional advantages such as good interface characteristic and simple process. In addition, for requirements of thickness and deposition temperature, the third layer of the SiO2 film is deposited by plasma enhanced chemical vapor deposition(PECVD). The deposition of the SiO2 film by PECVD is a low-temperature process and has a high deposition rate, which causes little damage to the device and makes the SiO2 film very suitable for serving as the third passivation layer. The passivation approach of stacks can saturate dangling bonds at the interface between stacks and the silicon substrate, and provide positive charge to optimize the field passivation of the n-type substrate.The passivation method ultimately achieves a good combination of chemical and field passivations. Experimental results show that with the passivation structure of SiO2/Al2O3/SiO2, the final minority carrier lifetime reaches 5223 μs at injection of 5×10¹⁵ cm^-3. When it is applied to the passivation of SDD, the leakage current is reduced to the order of nA.     

相匹配契伦可夫辐射式倍频

用波导产生倍频波时,如果倍频波进入辐射模区,仍然有相匹配问题。契伦可夫辐射式倍频不是自动地实现相匹配的。相匹配要求导波基波模式场,倍频传输场(自由波),倍频触发场,以及经多次反射透射后的辐射场的迭加形成的总辐射场处于同步的相匹配状态。根据这个相匹配的分析,提出波导契伦可夫相匹配的特有的方法,那就是对波导的模色散进行设计,并指出非对称波导的特有优点,是改变一个边界上的反射相变,即选择不同色散的线性材料作包层,由此可得到相匹配的高效契伦可夫倍频辐射。     

基于硅波导的喇曼光放大器

在硅波导上添加反向偏压的PIN结构,当波导产生受激喇曼散射时,可以将波导中双光子吸收(TPA)产生的光生自由载流子扫出波导,降低了波导的非线性损失,极大地提高了硅波导中泵浦光对信号光的喇曼增益。为了应用已经非常成熟的硅工艺,并且应用硅波导使器件小型化,根据法布里-帕罗(F-P)腔和行波放大器理论,在硅波导两端的解理面蒸镀增透膜,应用这种波导的喇曼效应设计了一种光放大器,即基于硅波导的喇曼光放大器。建立了计算放大器增益的方程,给出了不同波导长度和输入功率情况下的放大器增益,得出适当增加波导长度和泵浦光功率可以得到较高喇曼增益的结论。基于硅的光放大器有较高的饱和功率且没有泵浦源的限制,通过调整泵浦激光的波长可以放大不同波长的信号光。     

左手介质椭圆光波导基模传播特性

在椭圆柱坐标系中，采用分离变量方法，得出了左手介质椭圆光波导本征方程的近似解，通过数值计算，分析了椭圆波导偏心率、左手介质的电容率、磁导率对椭圆光波导基模传播特性的影响，并将左介质光波导与右手介质光波导基模特性进行对比，得出左手介质光波导的基模特性与右手介质光波导基模特性差别不大的结论.     

Confinement in a planar waveguide with porous silicon omnidirectional mirrors as confining walls

We present the design and study of waveguide structures based on porous silicon where the light confinement is not due to the usual total reflection effect but to the use of photonic crystals (PCs) as confining walls. These PC are omnidirectional mirrors (OMs), consisting of the periodic repetition of two porous silicon layers with different refractive indices and thicknesses. They reflect the radiation for all angles of incidence within a frequency range called the omnidirectional band gap (OBG). We have followed the PC formalism to investigate the properties of the OM as a multimode waveguide: the number of modes within the band gap, their field spatial distribution and their confinement as a function of the frequency and the core thickness.     

转移矩阵法在负折射率介质材料平板波导中的应用研究

利用严格电磁理论，推导出了适用于负折射率介质材料光波导的转移矩阵，分析讨论了转移矩阵的性质和应用.利用转移矩阵方法，推导出导波层为负折射率介质材料、覆盖层和衬底为右手材料的三层对称介质光波导的本征色散方程.用图解法研究了负折射率介质波导中TE波的异常色散特性.在负折射材料介质波导中没有零阶模，最低阶为1阶模，并且有截止频率,只有波导参量满足一定条件的时候才会存在，导模的横向波数可以为实数和纯虚数，而正折射率介质波导导模的横向波数只能为实数.